Ranger Auto - Drive Owners Manual Model No. 5377 – 12HP. WARNING • A mower is a high speed cutting tool. Safety precautions must be observe
MAINTENANCE - Cutter Drive Lever Pivot; - Clutch/brake pedal pivot; See Fig.15 - Tie rod ball ends; Fig.11 - All connecting rod pivot points. NO
MAINTENANCE PARKING BRAKE Should always be checked for operation after clutch/brake rods have been adjusted. CUTTER DRIVE ADJUSTMENT 1. Move Cutte
MAINTENANCE AUTO DRIVE The Auto-Drive friction plates and drive pulleys are factory set for travel required along key shaft and this should not need
MAINTENANCE STEERING RODS Should not normally require resetting. 1. Loosen rod lock nut; (A) See Fig.11 2. Release the fixing bolt; 3. Turn tie
SAFETY AND INSTRUCTION DECALS Safety and Instruction decals are mounted on the RANGER Rear Engine Rider. Replace any that become damaged or illegible
CIRCUIT DIAGRAM AND SPARES ITEM DESCRIPTION PART No. 1 KEY SWITCH A07678 2 KEY A07679 3 BLADE SWITCH A06406 4 BRAKE SWTICH A06406 5
TROUBLE SHOOTING PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION Engine loses power 1. Oil level in crankcase in low 1. Add oil to crankcase
RANGER AUTO – DRIVE SPARE PARTS LIST ITEM PART No. DESCRIPTION * COMMON HARDWARE ITEM 1 A07937 Fuel Tank 2 A12005 Fuel Tank Ca
RANGER AUTO – DRIVE SPARE PARTS LIST ITEM PART No. DESCRIPTION * COMMON HARDWARE ITEM 1 A10260 Chassis Assembly 2 A10041 Height Selector S
SAFETY INSTRUCTIONS • A mower user must be in good physical condition and mental health and not under the influence of any drug or alcohol which mig
18
RANGER AUTO – DRIVE SPARE PARTS LIST ITEM PART No. DESCRIPTION * COMMON HARDWARE ITEM 1 A07691 Steering Wheel 2 A10212 Steering
RANGER AUTO – DRIVE SPARE PARTS LIST ITEM PART No. DESCRIPTION ITEM PART No. DESCRIPTION *COMMON HARDWARE ITEM 1 A12042 Drive Plate 5
RANGER AUTO – DRIVE SPARE PARTS LIST ITEM PART No. DESCRIPTION * COMMON HARDWARE ITEM 1 A07539 Seat 2 A07704 Seat Panel 3 A12255
RANGER AUTO – DRIVE SPARE PARTS LIST ITEM PART No. DESCRIPTION * COMMON HARDWARE ITEM 1 A10222 Cutterhead Assembly 2 A07195 Spi
Warranty Conditions: Australia Only Rover-Scott Bonnar Limited warrant that this machine is free from defects in material and workmanship. This warr
SAFETY FEATURES Traction drive, blade drive and seat safety interlock Low centre of gravity, stable wide track Enclosed drives Parking
SPECIFICATIONS ROVER RANGER Machine Model No. 5377 Engine Model No. 281707 Single Cylinder Briggs & Stratton 4 Stroke 12
LOOSE PARTS KIT DESCRIPTION Steering wheel Roll Pin Stone Guard Assy. Spring Stone Guard ‘E’ Clip Ignition Keys Plug Spanner QTY 1 1 1 1 1 1 1 USE
BEFORE OPERATING FILL CRANKCASE WITH OIL The rider mower may be delivered without oil in the crankcase. Oil must be added before attempting to start
OPERATING INSTRUCTIONS AUTO – DRIVE OPERATION Forward and backward movement of the mower is controlled by the drive selector pedal. As with a moto
MAINTENANCE INTERVAL CHART See Page 5 Hours 25 Hours PERIODIC SERVICE EVERY 25 HRS 50 75 100 125 150 175
MAINTENANCE COOLING SYSTEM The Ranger has an air cooled 4 stroke engine. It must be cleaned frequently. Remove any build-up of grass, dirt or other
Comments to this Manuals