Safe Operation Practices Set-Up Operation Maintenance Service Troubleshooting OPERATOR’S MANUALWARNINGREAD AND FOLLOW ALL SAFE
- 10 - OILFuelMixing RatioWarnings1. Only use high quality air cooled 2-stroke engine oil. Never use water cooled engine oil or any oil for
- 11 - STARTING COLD ENGINEWARNING : Before starting the engine, keep the cutting attachment clear of everything around it.1. Use the mixing tan
- 12 - STARTING WARM ENGINESTOPPING INSTRUCTIONS1. Push the ignition switch to the “START” position2. Move the choke lever to the“HALF OP
- 13 - FUEL FILTERAIR FILTERCARBURETOR 1. Empty the fuel tank.͖ǤƤ
- 14 - 3. Every unit had been run and tested at the factory to ensure that the carburetor works at its best condition. But after a pe
- 15 - 1. Stop the engine to check if there is enough lubricating grease in the gear case after every 25 hours of use.2. Remove th
- 16 - CLEANINGLONG-TERM STORAGETRANSPORTATIONSTORAGE͕Ǥơ
- 17 - Problem Cause RemedyEngine does not start1. Spark plug wire disconnected.2. Ignition switch set to OFF.3. Fuel tank empty.4. Stale or improperl
- 18 - Problem Cause RemedyEngine has no power or stops during cutting1. Spool head or blade entangled with grass.2. Dirty air/oil filter.3. Stale or
- - SPECIFICATIONSpecication XT143 XT133Engine: Air cooled 2-stroke engine Air cooled 2-stroke engineDisplacement: 42.7cc 32.6ccCarburator: Diaphrag
- 2 - UMBERMNODELUMBERSNERIAL□□□□□□□□□□□ □□□□□□□□□□□Thank you for purchasing a Brushcutter manufactured by MTD Asia. It was carefully engineered to
- 20 - NOTES
- 21 -
- - Description Qty.1. Main Unit˄Including U handle˅12. Deluxe Back Pack Harness 13. Cutting Blade 14. Cutting Attachment Shield 15. Trimmer Head (I
1. Read, understand, and follow all instructions on the machine and in the manual before attempting to assemble and operate. Make sur
- 4 - 18. The rotary spool head and/or the cutting blade may keep running for a short time just after your shutting it down. Always
Indicates danger,warning or a reason to be cautious.Can be used together with other symbols or pictograms.SAFETY AND WARNING SYMBOLNon-compliance with
RUNSTARTOFF/STOPIGNITION SWITCHƫǡǤǤ
Gear CaseCutting Attachment ShieldShaft TubeClamping Bracker For Cutting Attachment ShieldU-HandleHip PadAir Filter CoverFuel TankChoke LeverIgnition
INSTALL AND ADJUST THE U-HANDLE2. You can adjust the operating angles of the handle by loosening the handle locking knob.Align the two holes
3. Install the blade holder and blade holder cover one by one.4. Finally, install the locking nut and tighten it by the hex wrenc
Comments to this Manuals