Rover Land Discovery Specifications download pdf (Page 89)

100

101

ENGINE

REPAIR

CAMSHAFT DRIVE BELT AND GEARS

Service repair no - 12.65.18

TIMING BELT

Remove

1. Remove front cover plate.

See Front Cover

Plate

2. Position engine at TDC on No. 1 cylinder.

3. If manual gearbox: Remove blanking plug from

flywheel housing and insert timing tool

LRT-12-044. If EDC - timing tool LRT-12-085

must be used.

If automatic gearbox:Sited to the rear of the

engine sump on engine backplate is a blanking

plate. Remove 2 blanking plate bolts and insert

timing tool LRT-12-044 into the larger bolt hole.

4. Engage timing tool pin with slot in flywheel.

5. Check correct alignment of timing mark on

camshaft gear and that crankshaft key aligns

with cast arrow on housing.

6. Insert pin from special tool LRT-12-045 in

injection pump gear and through into pump

flange.

NOTE: If the camshaft gear is to be

removed during these operations its

retaining bolt should be slackened before

the timing belt is removed.

7. Slacken belt tensioner bolt.

8. Remove idler pulley.

9. Remove timing belt.

NOTE: During use, a belt develops a wear

pattern relative to its running direction, if

the original belt is to be re-used it must be

refitted so that it rotates in the original direction.

CAUTION: Belts must be stored on edge

on a clean surface and in such a manner

that bends are not less than 50 mm radius.

Do not bend belts at an acute angle or radius of

less than 50 mm, otherwise premature failure

could result.

10. Mark belt direction of rotation, using soft chalk,

to ensure correct refitment.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 872 873

Comments to this Manuals

No comments

Rover Land Discovery Specifications Page 89

Comments to this Manuals

Related products and manuals for Cars Rover Land Discovery